Types Of Finishes

The following information is supplied by Timber Queensland the body responsible for researching and preparing industry standards.  JB Floor Sanding is a member of Timber Queensland in order to maintain a high level of industry knowledge and ongoing staff development.  Clients are welcomed to discuss any concerns with our professional staff or directly with Timber Queensland

Timber Floor Finishes

Timber floor finishes can be grouped into the four broad categories. These are the oil-based finishes, composite finishes (mixes of oil-based and solvent based polyurethane finishes), solvent based polyurethane finishes and water based finishes. With time all finishes will change in colour and film build as the wears. Therefore the ability to touch up becomes more difficult with time, however all coatings can be restored by recoating. In the long term a re-sand and refinish may be necessary depending on the wear and age of the floor.

Oil-Based Finishes

Oil-based finishes (alkyd/oleoresins) are the more traditional types of finish manufactured by reacting a natural oil (e.g. linseed and tung) with another chemical. Varnishes and the traditional tung oils fall within this category and are associated with the polished and waxed timber floors of the past. These types of finishes are still available and require greater regular maintenance than the other finishes. However, with the use of acrylic floor polishes, they have become easier to maintain. These finishes will darken with time. They are unlikely to edge bond boards.

Composite Oil-Based/Solvent Borne Finishes

Finishes containing oil-based alkyds with the addition of urethanes provide a finish with reasonably good abrasion resistance. Oil modified urethanes, which are one of the predominant floor finishes used in the USA and many of the ‘tung oil’ based finishes are of this type. The odour during application is very strong but dissipates as the finish dries. These finishes provide a subdued, satin to semi-gloss appearance and are unlikely to edge bond boards. They darken with time and require more frequent maintenance particularly in high traffic areas. Acrylic floor polishes may be used to protect the finish.

Solvent Borne Polyurethane Finishes

Solvent based polyurethanes (one pack and two pack) provide a harder finish, generally with limited flexibility but much greater abrasion resistance. Consequently, this greatly reduces the level of routine maintenance. They currently provide some of the hardest finishes available today with gloss levels from matt through to a very high gloss. These finishes, as with the oil-based finishes, will generally darken with time. The odour during application is very strong with these products but dissipates as the finish dries. Due to their high strength and generally limited flexibility, edge bonding of boards can occur.

Water Borne Finishes

Some water based polyurethane/acrylic mixes of moderate durability are available but straight one and two pack water based polyurethanes with very good wear resistance are gaining in popularity. These finishes are generally applied over a sealer (either solvent or water based), that not only enhances the colour of the timber but can significantly reduce the risk of edge bonding. Rapid shrinkage in the floor and the associated stretching of the finish at board joints has on occasions caused the appearance of light coloured lines at board joints. Matt through to gloss finishes are available and these finishes generally darken little with time. During application there is low odour associated with water based finishes. A curing additive (catalyst) may or may not be recommended by the manufacturer.

Read about > Types and Characteristics of Available Finishes

Commercial Jobs

    Commercial Floor Sanding and Polishing

Residential Homes

    Residential Floor Sanding and Polishing

Renovations

    Renovation Floor Sanding and Polishing

Stairs and Hallways

    Renovation Floor Sanding and Polishing

Decks and Verandahs

    Renovation Floor Sanding and Polishing